I just got in an NSA 2650 and I am trying to set this up for my network. I am planning to try to put it in place tomorrow but not sure if I have the configuration correct. I have a multiple site network using a private MPLS network from my provider. All Internet traffic will go through here. My network is similar to the picture below where I have multiple sites behind a router at the same site as the firewall. I put in a route to the first network to point to the router and that should cover it and that looked right. The problem with my configuration is that after I setup the first route, for the second and consecutive routes, they are "grayed out". It took them, but from the interface, it doesn't appear that they are active. Maybe I am just reading too much into this, but I want to make sure that I don't have routing problems when I...
↧