I've been doing a lot of command-line programming of Sonicwalls lately. The latest generation firmware has a fully functional CLI interface. So, here's the issue....
As per Sonicwall, I should be able to copy and paste 1000 lines at a time into an SSH session or console (serial) connection.
Using Putty, I connect with the serial management cable and copy/paste the CLI instructions. After about 20 lines, lines start getting dropped and then the errors start.
If I connect with SSH, I can copy about twice as many lines, and then the same issue.
I have tried this from a Windows 10 PC and a "clean" Windows 7 PC. By clean, I mean it's a clean install with all the updates and no other software.
It looks to be a buffering problem and I've messed with the port buffering on the PCs, but it make no change in the behavior.
Does anyone out there use...